Manufacturer by Type

Products by Category


Warning
  • COM_VIRTUEMART_MEDIA_CHOOSE_TYPE

Tabor 9100A 400Vp-p Single-Channel Signal Amplifier

PDFPrintEmail
Model 9100A was designed as a general purpose, wide band and high voltage amplifier however, with specific applications in mind.
Price:
Manufacturer: Tabor
Description

Model 9100A was designed as a general purpose, wide band and high voltage amplifier however, with specific applications in mind. It is built in a small case size to save space and cost but without compromising bandwidth and signal integrity.

    Single channel

    High voltage output to 400Vp-p (±200V)

    Output current to 125 mA

    Full power bandwidth from DC to >500kHz

    Slew rate to 400V/µs

    Monitor Output

    Precise signal amplification for multiple applications

    Compatible with any of the Tabor waveform generators

Solve Common Problems
Model 9100A can output signals from -200V to +200V with continuous currents up to 125mA. The output is driven from a 0.1Ω source and, with some degradation of its bandwidth, can drive capacitive loads up to 1nF, while maintaining its full amplitude range. Model 9100A/9200A has a rear-panel monitor output that divides the main output signal by 100 for applications that require monitoring of the output signal with low voltage sensors.

Target Applications The amplifier case was designed to stack on top or below other Tabor products. It can also be mounted alongside a Tabor generator in a standard 19" rack. The waveform-amplifier combo is an ideal solution for virtually any high-voltage, wide bandwidth application.

Safety
Safety played a major role during the design of the Model 9100A. The high voltage path to the amplifier circuit is blocked by a front panel mechanical switch and accidental application of high power to the UUT is prevented by a safety latch. The 9100A will output high voltage signals only after the safety latch has been lifted and the high voltage switch flipped to ON position. In emergency situations, one can hit the protective latch to immediately remove the high voltage power from the output terminals. As an additional visual safety feature, a red light glows on the front panel whenever the high voltage is turned on.